Filter By
There are 12 products.
T091 - ALU ADJUSTABLE SERVO HONE (for SANWA)
Adjustable the range of servo horn four stages at 17, 18, 19, 20mm. Since leverage can be set fixed, the setting is possible in a quantitiative way. Exquisitely machined from High-intensity alloy aluminum. Can fit to other chassis than IF14. (23 spline)
T092 - ALU ADJUSTABLE SERVO HONE (for FUTABA)
Adjustable the range of servo horn four stages at 17, 18, 19, 20mm. Since leverage can be set fixed, the setting is possible in a quantitiative way.
Exquisitely machined from High-intensity alloy aluminum. Can fit to other chassis than IF14. (25 spline)
T093 - ALU BELLCRANK 18mm (7075/Black/2pcs)
Since its hard stiffness effect, improved steering response can be provided.
Newly designed shape achieved further steering angle.
In case this aluminum bell crank equipped, please use together with D.J.CVD Ver2(T110).
T100 - ALU HEX WHEEL HUB (4.5mm/Black/2pcs)
0.5mm thinner than kit normal(5mm). Usefull to make the width narrow.
T101 - ALU HEX WHEEL HUB (4.25mm/Black/2pcs)
0.75mm thinner than kit normal(5mm). Usefull to make the width narrow.
T113 - D.J.CVD JOINT COVER TUBE (10x50mm/2pcs)
It is preventable G-Clip accidentally comming off during running.
Its approx. of 0.2mm thickness provide no weight extendability.
Shutterproof of grease and lenghtening life-span of the parts and maintenance cycle.
Cut about 10mm for each. Fitting on effectively, provide little heating after inserted.
T121 - VZ STEERING BLOCK (Graphite/Super Hard)
Newly designed steering block. Steering angle stopper is additionally equipped.
Steering is adjustable at any angle of incidence. Lineup of Hard & Graphite material.
Hard material is suitable for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.
T123 - VZ REAR UPRIGHT (Graphite/Super Hard)
Newly designed rear upright, geometry of suspension system is optimized. Toe angle is zero.
Mounting position of upper arm is optimized at higher point, shim of 2.0mm to be reduced.
Lineup of Hard & Graphite material. Hard material suits for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.
T138 - ALU SHOCK SPRING RETAINING COLLAR (Black/4pcs)
This shock spring retaining collar is for INFINITY IF14 shock. Made of precisely machined aluminium its extremely light and helps the shock absorber and the shock spring work more efficiently. The set contains 4pcs. of black-anodized shock spring retaining collars.