This update includes:
Newly developed shock pistons
Newly developed shock plastic parts
Newly developed shock shafts
G300 includes the short shock-type shock stay (G215).
Newly Developed Shock Pistons:
The new 4-hole pistons are designed to provide more damping at higher piston speeds, resulting in a more stable car behavior and improved drivability.
The total hole area is the same as the 2 × 1.1 mm or 3 × 0.9 mm pistons, making it easier to quantify and tune your setup.
Newly Developed Shock Plastic Parts:
The damper ends now feature a flanged design, and the spring retainer system has been revised to allow for an additional 2 mm of stroke.
Two types of spring retainers are included: one with the same specification as the previous model, and one that lowers the spring position by 2 mm.
Lowering the spring allows it to move more freely, increasing grip.
Newly Developed Shock Shafts:
With revised shaft lengths—G299: 28.5 mm, G300: 25.5 mm—the new shock shafts, when used in combination with the newly designed plastic parts, enable the IF15-2 to utilize its full shock stroke potential.
The 25T throttle servo horn, crafted from 7075-T6 alloy, serves as an ideal replacement for the plastic counterpart provided in the kit. Its robustness and precision enable maximum performance from your brakes, while the minimized play between the servo horn and servo ensures precise control over your engine.
This item constantly stabilizes high-speed driving by regulating the air flow inside the rear wheels. This separate type allows for quick rear grip adjustment, such as removing only the lower section.
The standard screws for the IF14-2 kit available in 10pcs packs. The screws used in all INFINITY kits are made of high performance steel and made in Japan. They are extremely stable and strong when tightened. Recommended not only as a spare part but also as a setting option.
Adding this spacer 1pc at each lower suspension holder, same rate can be derived with the eccentric bushing the position 0.5.
With this smart spacer, no need to taking off suspension holder for speedy operation.
Precision-machined from 7075-T6 aluminum and treated with INFINITY’s original hard coating for a lightweight, high-rigidity, and highly durable finish.
Delivers sharp throttle response and consistent handling for elevated driving performance.
Includes joint parts with the same material and coating as the drive shaft.
Reviewed steering angle, front D.J.CVD drive shaft.
With use of aluminum bell crank (T093), smoothly can provide the drive power at wide steering angle.
Assemblage of wheel axle and drive shaft must be Ver.2 -to-Ver.2
Mounting a 30mm size cooling fan directly above the motor allows for efficient cooling of the motor.
(The 30mm size cooling fan is sold separately. <SMJ1188B> It is recommended to use the SMJ Super High-Speed Cooling Fan 30mm.)
Crafted from 7075-T6 alloy, these washers offer superior durability compared to the plastic ones provided in the kit, thanks to their hard coating.
