• New

B03205 - M2x5mm CAP HEAD SCREW (6pcs)

This update includes:
Newly developed shock pistons

Newly developed shock plastic parts

Newly developed shock shafts

G300 includes the short shock-type shock stay (G215).

Newly Developed Shock Pistons:
The new 4-hole pistons are designed to provide more damping at higher piston speeds, resulting in a more stable car behavior and improved drivability.
The total hole area is the same as the 2 × 1.1 mm or 3 × 0.9 mm pistons, making it easier to quantify and tune your setup.

Newly Developed Shock Plastic Parts:
The damper ends now feature a flanged design, and the spring retainer system has been revised to allow for an additional 2 mm of stroke.
Two types of spring retainers are included: one with the same specification as the previous model, and one that lowers the spring position by 2 mm.
Lowering the spring allows it to move more freely, increasing grip.

Newly Developed Shock Shafts:
With revised shaft lengths—G299: 28.5 mm, G300: 25.5 mm—the new shock shafts, when used in combination with the newly designed plastic parts, enable the IF15-2 to utilize its full shock stroke potential.


16 other products in the same category:

  • New

G304-16 - HARD CHROME PLATING 1st PINION GEAR 16T

A high-precision pinion gear machined from A7075-T6 material, featuring a special high-hardness plating treatment that significantly enhances wear resistance for the IF15-2 series.
Previous models (G071-15, G071-16, G072-20, G072-21, G270-16, G271-21) will be discontinued once current stock is depleted.

  • New

G289 - REAR HUB (for Long Arm Offset)

The original rear hub <G009B> has been completely redesigned, with a wheel offset of 2mm to accommodate longer arms and additional ribs to improve overall hub rigidity.
The change in suspension geometry stabilizes the rear behavior, leading to improved and stable lap times.

*Two 3x5x1.0mm <A73510> spacers are required for the upper rear hub.

M026 - SERVO SAVER ALU SPACERS (2pcs)

These 7075-T6 spacers serve as replacements for the plastic ones included in the kit. Offering a longer lifespan compared to their plastic counterparts, they effectively maintain smooth servo saver movement even under the load exerted by the steering links.

T122 - VZ REAR UPRIGHT (Hard)

Newly designed rear upright, geometry of suspension system is optimized. Toe angle is zero.
Mounting position of upper arm is optimized at higher point, shim of 2.0mm to be reduced.
Lineup of Hard & Graphite material. Hard material suits for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.

T360 - IF14-2MID PASSIVE REAR STEERING (PRS) SET

The most advanced ""PRS system"" will deliver faster cornering speed for IF14. As a result of the stroke from suspension arm, toe angle is controled passively. Amount of toe angle is fine-tuned by the mounting angle of the linkage rod.
Rear caster angle is -2 deg.