T268 - REAR BODY HEIGHT FITTER (for HBP)
When using the HBP mount it can be difficult to accurately position the rear body post holes in the bodyshell. By using this rear body height fitter it is quick and easy to precisely position the body post holes at the desired body height.
16 other products in the same category:
T252 - CENTER BALANCE WEIGHT 7.5g (2pcs)
7.5g balancing weight that can be attached to the 15g center weight or the aluminum electronic plate mount. Weight balance can be adjusted by the mounting position and the number of weights.
T302 - USP GRAPHITE FLEX REAR SHOCK TOWER
By reducing the rigidity of the rear shock tower connecting point to the upper bulkhead, the stiffness around the rear bulkhead is reduced and the overall chassis flex is increased allowing for smoother rear rotation. For normal body post.
T270 - LIGHT WEIGHT D.J.CVD CROSS SPIDER (4pcs)
A lightweight DJ CVD cross spider using high strength super duralium (A7075) to reduce the weight by approx 36% compared with standard steel. High durability is also achieved by applying a hard alumite treatment. Used in combination with T227LW lightweight DJ CVD joint it is possible to reduce the weight by about 2g per driveshaft.
T261 - GRAPHITE FRONT BODY POST SUPPORT
This front bumper brace improves the rigidity of the bumper and body posts, helping stability around the front section at high speed. Made from lightweight and highly rigid carbon, the product surface is also specially embossed to achieve a stylish design which includes the INFINITY logo. Your IF14-2 will look even more dialled with this brace installed.
T091 - ALU ADJUSTABLE SERVO HONE (for SANWA)
Adjustable the range of servo horn four stages at 17, 18, 19, 20mm. Since leverage can be set fixed, the setting is possible in a quantitiative way. Exquisitely machined from High-intensity alloy aluminum. Can fit to other chassis than IF14. (23 spline)
T162 - ALU ECCENTRIC BEARING HOLDER 0.5mm (Black/2pcs)
This ALU ECCENTRIC BEARING HOLDER 0.5mm is 0.3mm less offset than the standard bearing holder. This allows you to have a wider choice of adjustment with a 0.3mm lower diff in the 'high' position and 0.3mm higher in the 'low' position. This part is machined from high quality aluminium for minimised drivetrain loss.
When using the HBP mount it can be difficult to accurately position the rear body post holes in the bodyshell. By using this rear body height fitter it is quick and easy to precisely position the body post holes at the desired body height.