T101 - ALU HEX WHEEL HUB (4.25mm/Black/2pcs)
0.75mm thinner than kit normal(5mm). Usefull to make the width narrow.
16 other products in the same category:
T301 - USP GRAPHITE FLEX FRONT SHOCK TOWER
By reducing the rigidity of the front shock tower connecting point to the upper bulkhead, the stiffness around the front bulkhead section is reduced and the overall chassis flex is increased, resulting in a calmer initial steering response. This reduction in initial stiffness helps smooth out cornering and can help reduce tyre wear.
T199-0.2 - LOWER SUSPENSION BLOCK SPACER FR 0.2mm (SUS/4pcs)
This spacer sits between the lower suspension block and the chassis to adjust the roll center. With a thickness of 0.2mm it's possible to achieve fine detailed setup.
T249 - IF14-2 BULKHEAD ALIGNMENT TOOL SET
Alignment tool to accurately assemble the IF14-2 lower bulkhead, upper bulkhead and shock tower.
T091 - ALU ADJUSTABLE SERVO HONE (for SANWA)
Adjustable the range of servo horn four stages at 17, 18, 19, 20mm. Since leverage can be set fixed, the setting is possible in a quantitiative way. Exquisitely machined from High-intensity alloy aluminum. Can fit to other chassis than IF14. (23 spline)
T269S - GRAPHITE UPPER BULKHEAD BRACE (Soft)
Adjust the chassis flex by connecting this carbon brace between the upper bulkheads on top of the top deck. This upper bulkhead brace is cut with high precision from 1mm carbon plate and can change the steering and traction characteristics by effecting the rigidity of the front or rear bulkheads.
Front of top deck: Good balance between high-speed and low-speed corner.
Rear of top deck: Good balance between rotation and traction.
T308H - STEERING BLOCK / REAR UPRIGHT SET (IF14-2/Hard)
One car set of steering block and rear uprights (hard) for IF14-2 and IF14-2FWD.
This set is convenient for when you want to replace these items together for maintenance. It is also more economical than purchasing each item individually.