T113 - D.J.CVD JOINT COVER TUBE (10x50mm/2pcs)
It is preventable G-Clip accidentally comming off during running.
Its approx. of 0.2mm thickness provide no weight extendability.
Shutterproof of grease and lenghtening life-span of the parts and maintenance cycle.
Cut about 10mm for each. Fitting on effectively, provide little heating after inserted.
16 other products in the same category:
T260 - IF14-2 TITANIUM BALL END 4.9mm SET (18pcs)
This is a new set of super strong and high-precision 4.9mm titanium ball ends for the IF14-2.
Each set is about 8g lighter than the steel ones and the polished ball surface ensures the ball end moves smoothly for a long time.
T307H - LOWER SUSPENSION ARM SET (IF14-2/Hard)
A full set of lower suspension arms (hard) for IF14-2 and IF14-2FWD for one car.
This set is convenient when you want to replace lower suspension arms together for maintenance. It is also more economical than purchasing each item individually.
T092 - ALU ADJUSTABLE SERVO HONE (for FUTABA)
Adjustable the range of servo horn four stages at 17, 18, 19, 20mm. Since leverage can be set fixed, the setting is possible in a quantitiative way.
Exquisitely machined from High-intensity alloy aluminum. Can fit to other chassis than IF14. (25 spline)
T143 - WHEEL SHIM 0.25mm (SUS/8pcs)
By adding these wheel shims between the hex wheel hub and the wheel, you can fine-tune the cars track width quickly. Available in two thicknesses of 0.25mm and 0.5mm. 8pcs are included in each.
T338 - COMPOSITE COOLING FAN MOUNT for FLOATING ELECTRONIC PLATE
Cooling fan mount made of composite material that is half the weight of aluminum and super lightweight.
T302 - USP GRAPHITE FLEX REAR SHOCK TOWER
By reducing the rigidity of the rear shock tower connecting point to the upper bulkhead, the stiffness around the rear bulkhead is reduced and the overall chassis flex is increased allowing for smoother rear rotation. For normal body post.
T252 - CENTER BALANCE WEIGHT 7.5g (2pcs)
7.5g balancing weight that can be attached to the 15g center weight or the aluminum electronic plate mount. Weight balance can be adjusted by the mounting position and the number of weights.
T227LW - LIGHT WEIGHT D.J.CVD JOINT (2pcs)
Lightweight DJ CVD joint that is approx 1.2g lighter than standard steel (approx 1.8g) by using lightweight and high strength super duralium (A7075). Throttle response is improved by reducing the rotating mass, while front tyre wear and understeer is reduced.
T303 - USP GRAPHITE FLEX REAR SHOCK TOWER (for HBP)
By reducing the rigidity of the rear shock tower connecting point to the upper bulkhead, the stiffness around the rear bulkhead is reduced and the overall chassis flex is increased allowing for smoother rear rotation. For HBP (Horizontal body post)
T301 - USP GRAPHITE FLEX FRONT SHOCK TOWER
By reducing the rigidity of the front shock tower connecting point to the upper bulkhead, the stiffness around the front bulkhead section is reduced and the overall chassis flex is increased, resulting in a calmer initial steering response. This reduction in initial stiffness helps smooth out cornering and can help reduce tyre wear.