16 other products in the same category:
T144 - WHEEL SHIM 0.5mm (SUS/8pcs)
By adding these wheel shims between the hex wheel hub and the wheel, you can fine-tune the cars track width quickly. Available in two thicknesses of 0.25mm and 0.5mm. 8pcs are included in each.
T123 - VZ REAR UPRIGHT (Graphite/Super Hard)
Newly designed rear upright, geometry of suspension system is optimized. Toe angle is zero.
Mounting position of upper arm is optimized at higher point, shim of 2.0mm to be reduced.
Lineup of Hard & Graphite material. Hard material suits for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.
SMJ1004 - SILVER LINE SPRING TS3.5 (Short/Gold/2pcs)
New standard Short-type shock springs (20mm). We selected wire 1.4mm in diameter and accurately coiled and plated it. Gold: 5 Coils For high- grip asphalt road surface Made in Japan
T131 - LOWER SUSPENSION HOLDER SPACER 0.4mm (4pcs)
Adding this spacer 1pc at each lower suspension holder, same rate can be derived with the eccentric bushing the position 0.5.
With this smart spacer, no need to taking off suspension holder for speedy operation.
T162 - ALU ECCENTRIC BEARING HOLDER 0.5mm (Black/2pcs)
This ALU ECCENTRIC BEARING HOLDER 0.5mm is 0.3mm less offset than the standard bearing holder. This allows you to have a wider choice of adjustment with a 0.3mm lower diff in the 'high' position and 0.3mm higher in the 'low' position. This part is machined from high quality aluminium for minimised drivetrain loss.
T090 - CHASSIS MOUNTED ALU STEERING POST (Red/2pcs)
We recommend using the Chassis Mounted Alu. Steering Post when better steering response is needed. INFINITY red anodized production visually effects everyone.
T146 - PRO-GEAR DIFF SET (38T)
The newly designed gear differential for IF14 offers smooth rotation and high rear traction in all conditions. The differential shafts are now supported by ball bearings for added stability and consistency during runs. Outdrive cups can now be replaced from the outside without the need to open the diff making maintenance quick and easy.
T110 - D.J.CVD DRIVE SHAFT SET Ver.2 (1pc)
Reviewed steering angle, front D.J.CVD drive shaft.
With use of aluminum bell crank (T093), smoothly can provide the drive power at wide steering angle.
Assemblage of wheel axle and drive shaft must be Ver.2 -to-Ver.2