A006-10 - ALUMINUM WASHER 3x6x1.0mm (Black/10pcs)

A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.

Spare part for R0337

Uses lightweight carbon material. Chassis rigidity can be increased while suppressing weight increase. Improves steering response.

The front roll center can be lowered by replacing the kit parts with this front knuckle base. With these adjustments your IF18-II has the potential for even higher turning/steering performance. Recommended for use with thick front stabilizer from 2.6 - 3.0mm.

This carbon plate is used in combination with R00220L long front body post to increase the rigidity around the front bulkhead. Response in initial steering is increased while still maintaining a mild steering feel in the middle part of the corner. Also offering a weight saving of 4g the standard kit body mounting.

Change of contents of conventional R0067 (to 1 piece).
Changed to 1 piece to make it easier to purchase as a spare part.

Upper arm holder machined from 7075 aluminuim material. The strength and rigidity are increased providing higher corner speed in certain conditions. The black anodized finish complete with Infinity logo also add a cool look to your car.

Titanium UFO head screw. Offers a lightweight design while maintaining contact surface area.

Spare part for R0333.

A brass battery plate that concentrates the weight in the center of the car body and increases the chassis rigidity achieves higher driving stability. In particular, it is easy to control on a high-grip road surface and prevents traction roll.

This part is machined from high quality 7075 aluminium material. With the significantly increased rigidity the steering response will be improved. Plastic bushings to hold the suspension shaft and mounting screws are included.

A carbon stiffener that can be added to the front lower arm to increase rigidity. Increased steering response and higher cornering speeds can be achieved in certain conditions. Its also possible to adjust the flex and rigidity by the number of mounting screws used.