R0217-10 - SERVO SAVER NOSE (10mm) CARBON GRAPHITE

Long life rubber belt

Lightweight and strong 64 titanium material is precision-machined to increase the overall length and ensure rigidity even when the rear upper arm is set at its longest setting. (Use with R0343 is recommended)

DISCONTINUED

Standard part for IF18-2

A new aluminium servo horn designed specifically for IF18. 25T specification for servos made by Savox (SC2271SG) and Futaba (BLS371SV). By making the shape of the arm offset it is possible to achieve the maximum steering angle with a linear steering operation. Use in combination with R0259 Aluminium servo saver (up side).

Uses lightweight carbon material. Chassis rigidity can be increased while suppressing weight increase. Improves steering response.

Front Shock Stay LD(Lay Down) that offers a position one step lower than the conventional R0081 (included in the kit). The center position of the R0336 is the same as the lower hole of the R0081. It's designed to be lower so that it does not interfere with the body even when a modern body is installed. Thickness is 2.5mm.

A new aluminium servo horn designed specifically for IF18. 23T specification for servos made by Sanwa and KO. By making the shape of the arm offset it is possible to achieve the maximum steering angle with a linear steering operation. Use in combination with R0259 Aluminium servo saver (up side).

For rear only

Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for central alignment of the upper pivot (0mm kit standard zero offset).

When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.

By moving the 3x11.8mm pin position of the universal shaft through
90 degrees this allows for a more free drive transmission at high RPM and a smoother suspension
movement under high load, overall offering an increased steering feel.

This Urethane belt provides high durability under harsh conditions such as driving on dusty or dirty tracks, high temperatures or long finals. The belt teeth are hard and highly accurate offering good compatibility with the tooth profile and material of the pulleys helping to maintain excellent drive efficiency.

To change ackerman angle (more increase angle of outside front tyre)