R0274 - CARBON FRONT BODY MOUNT PLATE(for LONG POST)
This carbon plate is used in combination with R00220L long front body post to increase the rigidity around the front bulkhead. Response in initial steering is increased while still maintaining a mild steering feel in the middle part of the corner. Also offering a weight saving of 4g the standard kit body mounting.
16 other products in the same category:
R0284 - LIGHT WEIGHT LIP SPOILER SET
This light weight lip spoiler set has a reduced weight of approx 5g including fastener and nut. Recommended for use with a lightweight bodyshell. Special carbon style features a printed INFINITY logo.
R0303-02S - FRONT SUSPENSION BUSH(IF18-2) SOFT
Uses a softer material than the standard R0303-01.
Steering response is more mild and easy to drive.
R0276 - IF18 CLUTCH TOOL
Adjust the amount of spring tension on your clutch nut quickly and easily without disassembling the clutch bell. Featuring the Infinity logo the tool is also finished in black and red to match the brands striking colours.
R0223 - BODY STIFFNER FOR 1/8 RACING L TYPE (CARBON GRAPHITE)
Body stiffener for 1/8 body (Only small type)
R8007B - FRONT BELT (URETHANE) 210
This Urethane belt provides high durability under harsh conditions such as driving on dusty or dirty tracks, high temperatures or long finals. The belt teeth are hard and highly accurate offering good compatibility with the tooth profile and material of the pulleys helping to maintain excellent drive efficiency.
R0217-09 - SERVO SAVER NOSE (09mm) CARBON GRAPHITE
To change ackerman angle (more increase angle of outside front tyre)
R0242 - REAR LOWER ARM PLATE LC (CARBON GRAPHITE) 2pcs
3.0mm shorter/Good matching for standard INFINITY(CM-00001)
R0346 - ALUMINUM FRONT WHEEL SHAFT(7075/1pc)
Change of contents of conventional R0067 (to 1 piece).
Changed to 1 piece to make it easier to purchase as a spare part.
R0327 - ALUMINIUM OFFSET BUSHING (IF18-2)
Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for -1mm/+1mm (trail/reverse trail) of the upper pivot.
When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.
R0284R - LIP SPOILER SET (Regular Weight)
Regular weight lip spoiler for 1/8 racing car body made of 0.8mm thick material.
Compared to the light weight (R0284), the lip spoiler itself is more rigid, enabling it to transfer downforce to the car body more effectively even at high speeds.
R0252T18 - 0.8M 1st PINION GEAR 18T
A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.