16 other products in the same category:
R0075-60R - FRONT UNIVERSAL SWING SHAFT 90°(L 60)2pcs
By moving the 3x11.8mm pin position of the universal shaft through
90 degrees this allows for a more free drive transmission at high RPM and a smoother suspension
movement under high load, overall offering an increased steering feel.
R0279 - REAR BUSHING SET(HARD/2sets)
Uses harder material than standard IF18 kit. Increases the rigidity of the suspension and improves the corner speed.
CM-A005-05 - ALUMINUM WASHER 3x6x0.5mm (Red/10pcs)
A vivid red anodized version has been added to the aluminum spacer series (3mm in inner diameter). It helps you dress up your machine. If you use this red anodized version and the black version in different specifications in a setting, you can easily distinguish them.
R0252T18 - 0.8M 1st PINION GEAR 18T
A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.
CM-A005-20 - ALUMINUM WASHER 3x6x2.0mm (Red/10pcs)
A vivid red anodized version has been added to the aluminum spacer series (3mm in inner diameter). It helps you dress up your machine. If you use this red anodized version and the black version in different specifications in a setting, you can easily distinguish them.
R0314 - FRONT KNUCKLE BASE 13.5(IF18-2)
The front roll center can be lowered by replacing the kit parts with this front knuckle base. With these adjustments your IF18-II has the potential for even higher turning/steering performance. Recommended for use with thick front stabilizer from 2.6 - 3.0mm.
R0303-02S - FRONT SUSPENSION BUSH(IF18-2) SOFT
Uses a softer material than the standard R0303-01.
Steering response is more mild and easy to drive.