Material is softer than kit normal. Higher drive efficiency achieved by narrowed belt. Exclusive use for stock motor.
The T142 drive belt is wider than T105 drive belt amking it the perfect choice for high power motors. Due to the low friction characteristics of the product, T142 drive belt has a shorter life than the drive belt included in the kit. If you use T142 drive belt with a modified motor, conduct maintenance regularly and replace the belt as necessary.
It is preventable G-Clip accidentally comming off during running.
Its approx. of 0.2mm thickness provide no weight extendability.
Shutterproof of grease and lenghtening life-span of the parts and maintenance cycle.
Cut about 10mm for each. Fitting on effectively, provide little heating after inserted.
Material is softer than kit normal. Higher drive efficiency achieved by narrowed belt. Exclusive use for stock motor.
Including 40mm size high speed cooling fan is mounted at back side of motor. Fan is fixed with two screws on the red anodized aluminum fan mount. Since this fan mount is fixed on chassis by one screw so as hardly can not effect chassis flex. Mount is usable for 30mm and 40mm size fan.
※ Not combination usage with T095 Rear balance weight (Left side).
※ Limited-production item.
The newly designed gear differential for IF14 offers smooth rotation and high rear traction in all conditions. The differential shafts are now supported by ball bearings for added stability and consistency during runs. Outdrive cups can now be replaced from the outside without the need to open the diff making maintenance quick and easy.
Newly designed rear upright, geometry of suspension system is optimized. Toe angle is zero.
Mounting position of upper arm is optimized at higher point, shim of 2.0mm to be reduced.
Lineup of Hard & Graphite material. Hard material suits for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.
Newly designed rear upright, geometry of suspension system is optimized. Toe angle is zero.
Mounting position of upper arm is optimized at higher point, shim of 2.0mm to be reduced.
Lineup of Hard & Graphite material. Hard material suits for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.
Cooling fan mount made of composite material that is half the weight of aluminum and super lightweight.
Newly designed steering block. Steering angle stopper is additionally equipped.
Steering is adjustable at any angle of incidence. Lineup of Hard & Graphite material.
Hard material is suitable for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.
New standard Short-type shock springs (20mm). We selected wire 1.4mm in diameter and accurately coiled and plated it. Gold: 5 Coils For high- grip asphalt road surface Made in Japan
Reviewed steering angle, front D.J.CVD drive shaft.
With use of aluminum bell crank (T093), smoothly can provide the drive power at wide steering angle.
Assemblage of wheel axle and drive shaft must be Ver.2 -to-Ver.2
Adjustable the range of servo horn four stages at 17, 18, 19, 20mm. Since leverage can be set fixed, the setting is possible in a quantitiative way. Exquisitely machined from High-intensity alloy aluminum. Can fit to other chassis than IF14. (23 spline)
Newly designed reviewing material and geometory. Durability is significantly advanced.
The new suspension holder provides 0.5mm lower than kit normal hinge pin point. Possible to lower the roll center. Combination of roll center and toe angle option, setting range is widen.
Material is softer than kit normal. Higher drive efficiency achieved by narrowed belt. Exclusive use for stock motor.