M146BK - IFB8 WING (BLACK)

Lower Bulkhead that allows the differential (spool) pulley height to be raised by 2mm compared to the standard kit specification.

This allows you to optimize the differential (spool) height when using the 1.5mm Aluminum Chassis (TS095) or Steel Chassis (TS096).

Note: Dedicated Upper Bulkheads (TS173 / TS174) are required.

Spare Part for T358

Low-friction center pulley in stylish black color specification.

INFINITY Team Hoodie has been renewed with the World Champion "4 Star" design!


The "4 Star" design represents the number of World Championships Team INFINITY has won. The design is a subtle yet proud reflection of Team INFINITY's brilliant achievements to date. Although it is a thin type, it is brush lined for a comfortable feel and excellent warmth retention. Seven sizes are available: S/M/L/XL/2XL/3XL/4XL.

The mounting orientation can be changed to match the battery used, allowing for more secure battery fastening.

Reviewed steering angle, front D.J.CVD drive shaft.
With use of aluminum bell crank (T093), smoothly can provide the drive power at wide steering angle.
Assemblage of wheel axle and drive shaft must be Ver.2 -to-Ver.2

The standard screws for the IF14-2 kit available in 10pcs packs. The screws used in all INFINITY kits are made of high performance steel and made in Japan. They are extremely stable and strong when tightened. Recommended not only as a spare part but also as a setting option.

This component is crafted from 7075-T6 alloy and features a hard coating. Its lightweight design (0.65 grams) allows you to cut weight from your transmission and achieve maximum performance. It can be installed on all the differentials of your vehicle.

A set of Droop Gauge (A2502) and Droop Block (A2504) required for droop measurement and adjustment. They are stored in a dedicated case, which securely protects the Droop Gauge and block from scratches during transport.

Upstop Set for limiting suspension arm up travel.
Allows fine-tuning of vehicle dynamics by adjusting the front and rear suspension arm up travel
Easily adjustable from the top of the chassis using a 1.5mm hex wrench.
Compatible with the 1.5mm Aluminum Chassis (TS095) and Steel Chassis (TS096).
Not compatible with the Carbon Chassis (TS093) and 2.0mm Aluminum Chassis (TS094).