Adjustable the range of servo horn four stages at 17, 18, 19, 20mm. Since leverage can be set fixed, the setting is possible in a quantitiative way. Exquisitely machined from High-intensity alloy aluminum. Can fit to other chassis than IF14. (23 spline)
Lightweight DJ CVD joint that is approx 1.2g lighter than standard steel (approx 1.8g) by using lightweight and high strength super duralium (A7075). Throttle response is improved by reducing the rotating mass, while front tyre wear and understeer is reduced.
Spare parts for IF14-2 aluminum & Titanium screw set (T245). Also suitable as a wing attachment screw for 1/10 scale cars.
This spacer sits between the lower suspension block and the chassis to adjust the roll center. With a thickness of 0.2mm it's possible to achieve fine detailed setup.
Precision machined pistons for USP shocks, 1.1mm x 3 holes.
This Piston outer diameter is the same as the kit standard piston (T208).
This is a new set of super strong and high-precision 4.9mm titanium ball ends for the IF14. Each set is about 8g lighter than the steel ones and the polished ball surface ensures the ball end moves smoothly for a long time.
It is preventable G-Clip accidentally comming off during running.
Its approx. of 0.2mm thickness provide no weight extendability.
Shutterproof of grease and lenghtening life-span of the parts and maintenance cycle.
Cut about 10mm for each. Fitting on effectively, provide little heating after inserted.
Adjust the chassis flex by connecting this carbon brace between the upper bulkheads on top of the top deck. This upper bulkhead brace is cut with high precision from 1mm carbon plate and can change the steering and traction characteristics by effecting the rigidity of the front or rear bulkheads.
Front of top deck: Good balance between high-speed and low-speed corner.
Rear of top deck: Good balance between rotation and traction.
This is a new set of super strong and high-precision 4.9mm titanium ball ends for the IF14. Each set is about 8g lighter than the steel ones and the polished ball surface ensures the ball end moves smoothly for a long time.
Conversion set to convert IF14-2 Team Edition (TE) to MID motor layout. Smooth cornering characteristics and improved weight transfer reduce the load on the rear tires, making lap times more consistent during the latter part of a race.
An extra hard lower suspension arm using a graphite material. This arm is more stiff than the original kit version and is suitable for high grip tracks and in situations when you want to improve initial steering response.
Adjustable the range of servo horn four stages at 17, 18, 19, 20mm. Since leverage can be set fixed, the setting is possible in a quantitiative way. Exquisitely machined from High-intensity alloy aluminum. Can fit to other chassis than IF14. (23 spline)