G086-2.2 - FRONT STABILIZER BAR 2.2mm

Spare parts for repairing short shocks that can be used for IF15/IF15W.

Overall length of 24mm.

High-grade Japanese bearings are used to create an extremely smooth drivetrain. The INFINITY logo is also included to prove that it is team spec.

Front upper arm spacer for IF15. By inserting these shims between the front upper arm holder and the upper deck its possible to fine tune the roll center and camber change rate, enabling smooth and high speed cornering.

This is a set of the servo saver parts, which are highly consumable parts included in the G012 servo parts set A. The set is available at a reasonable price.

This new hard type main chassis (G053) for IF15 was recently used to take the win at the 2018 World Championship in Miami. Featuring a stiffer rear section both traction and response is increased compared to that of the kit version.

This tension roller flange prevents the middle belt from accidentally falling off in high load situations such as high temps or extreme high traction. Fixed in place so as not to increase rotating mass of the roller it is also shaped to prevent any step between the belt and the flange. Offered in black and titian colour. (Can also be used for IF15. Please use the included M3x15mm screw.)

High-grade Japanese bearings are used to create an extremely smooth drivetrain. The INFINITY logo is also included to prove that it is team spec.

These engine mounts are specially designed for the O.S.12 engine. They are lowered and allow the engine crankcase to sit right at the chassis level contributing to a lower center of gravity.
The cooling fins on the sides allows the engine to better dissipate heat and help prevent overheating during a race.
(Do not use with non- O.S. engines as the crankcase and chassis may interfere with each other.)

G124 New 3 hole shock pistosn for IF15. Recommended for the front end on IF15 on med-high traction tracks to increase corner speed. Can also be used in the rear and IF18 shocks.