B01408U-T - M4x8mm TITANIUM UFO HEAD SCREW (8pcs)

A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.

Reverse movement from the standard type

This carbon plate is used in combination with R00220L long front body post to increase the rigidity around the front bulkhead. Response in initial steering is increased while still maintaining a mild steering feel in the middle part of the corner. Also offering a weight saving of 4g the standard kit body mounting.

1.5mm shorter

Now available as individual parts. R0303 is discontinued.

Regular weight lip spoiler for 1/8 racing car body made of 0.8mm thick material.
Compared to the light weight (R0284), the lip spoiler itself is more rigid, enabling it to transfer downforce to the car body more effectively even at high speeds.

As used by the team drivers at the 2019 World Championships. The chassis offers increased corner speed while also offering a smoother feel, this has been achieved by changing the shape of both the front and the rear of the chassis.
It is also possible to change the characteristics for different track conditions by adding a carbon plate (sold separately) to increase rigidity of the front section and adding an M3 screw to the rear. 

A carbon stiffener that can be added to the front lower arm to increase rigidity. Increased steering response and higher cornering speeds can be achieved in certain conditions. Its also possible to adjust the flex and rigidity by the number of mounting screws used.

To change ackerman angle (more increase angle of outside front tyre)

Titanium UFO head screw. Offers a lightweight design while maintaining contact surface area.

Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for -1mm/+1mm (trail/reverse trail) of the upper pivot.

When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.