R0047 - STABILIZER STOPPER 2.6mm 2pcs

16 other products in the same category:

R0337 - REAR CARBON BODY MOUNT SET

Compared to the standard plastic rear body mount, this new carbon mount increases the height of the body by 3mm (Almost the limit within the regulation of IFMAR). In addition, the cross-sectional shape of the carbon plate and A7075 adapter matches the latest body shapes such as XTREAM's Diablo and Protoform's R19 without any gaps. This allows the downforce to be transferred to the tires without loss and improving rear grip. The left and right carbon plates can be fine-tuned with set screws to accommodate individual body shapes. The connection to the car body can be made in three step width directions, and also absorbs the twisting of the mounting part when toe-in is applied.

R0327 - ALUMINIUM OFFSET BUSHING (IF18-2)

Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for -1mm/+1mm (trail/reverse trail) of the upper pivot.

When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.

CM-A005-05 - ALUMINUM WASHER 3x6x0.5mm (Red/10pcs)

A vivid red anodized version has been added to the aluminum spacer series (3mm in inner diameter). It helps you dress up your machine. If you use this red anodized version and the black version in different specifications in a setting, you can easily distinguish them.

R0328 - ALUMINIUM CENTERING BUSHING (IF18-2)

Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for central alignment of the upper pivot (0mm kit standard zero offset).

When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.

R8007B - FRONT BELT (URETHANE) 210

This Urethane belt provides high durability under harsh conditions such as driving on dusty or dirty tracks, high temperatures or long finals. The belt teeth are hard and highly accurate offering good compatibility with the tooth profile and material of the pulleys helping to maintain excellent drive efficiency.