By moving the 3x11.8mm pin position of the universal shaft through
90 degrees this allows for a more free drive transmission at high RPM and a smoother suspension
movement under high load, overall offering an increased steering feel.
Maintenance and adjustability is greatly improved with this servo saver arm by mounting to the steering rod upper side. Also, by changing and optimizing the arm length of the servo saver, the steering response will be higher than before.
This Titainium screw set for the IF18 will effectively reduce the weight of the upper section of the car. Using these screws will slightly increase chassis flexibility allowing you to tune your car setup for any conditions. The set contains a total of 111pcs offering a weight saving of 18g over the standard steel screws.
To change ackerman angle (more increase angle of outside front tyre)
This Titainium screw set for the IF18 will effectively reduce the weight of the lower section of the car. Using these screws will slightly increase chassis flexibility allowing you to tune your car setup for any conditions. The set contains a total of 47pcs offering a weight saving of 12g over the standard steel screws.
R0262, R0263 Repair parts for accessories. Because it is an ultra-low head type with 1.5 mm hex hole and a thickness of 1.2 mm, it can be used in various tight spaces.
This tension roller flange prevents the middle belt from accidentally falling off in high load situations such as high temps or extreme high traction. Fixed in place so as not to increase rotating mass of the roller it is also shaped to prevent any step between the belt and the flange. Offered in black and titian colour. (Can also be used for IF15. Please use the included M3x15mm screw.)
To change ackerman angle (more increase angle of outside front tyre)
