R8021 - REAR SPRING φ2.0-8T

Body stiffener for 1/8 body

To change ackerman angle (more increase angle of outside front tyre)

New option part for INFINITY IF18. This new replacement body mount shaft with 3mm stopper not only improves the strength and reliability during long finals it also speeds up your maintenance time and allows for the body mount to move more freely. The shaft itself is a heat-treated high-strength spec with a polished finish.

This tension roller flange prevents the middle belt from accidentally falling off in high load situations such as high temps or extreme high traction. Fixed in place so as not to increase rotating mass of the roller it is also shaped to prevent any step between the belt and the flange. Offered in black and titian colour. (Can also be used for IF15. Please use the included M3x15mm screw.)

This Titainium screw set for the IF18 will effectively reduce the weight of the upper section of the car. Using these screws will slightly increase chassis flexibility allowing you to tune your car setup for any conditions. The set contains a total of 111pcs offering a weight saving of 18g over the standard steel screws.

 Use with R0188

This Titainium screw set for the IF18 will effectively reduce the weight of the lower section of the car. Using these screws will slightly increase chassis flexibility allowing you to tune your car setup for any conditions. The set contains a total of 47pcs offering a weight saving of 12g over the standard steel screws.

Adjust the amount of spring tension on your clutch nut quickly and easily without disassembling the clutch bell. Featuring the Infinity logo the tool is also finished in black and red to match the brands striking colours.

A brass battery plate that concentrates the weight in the center of the car body and increases the chassis rigidity achieves higher driving stability. In particular, it is easy to control on a high-grip road surface and prevents traction roll.

Super low friction rubber belt