A floating electronics plate which allows the receiver, ESC and motor cooling fan to be easily installed and removed from the chassis. Helps ease of maintenance and allows for quicker chassis changes.
This spacer sits between the lower suspension block and the chassis to adjust the roll center. With a thickness of 0.2mm it's possible to achieve fine detailed setup.
Precision machined pistons for USP shocks, 1.1mm x 3 holes.
This Piston outer diameter is the same as the kit standard piston (T208).
One car set of steering block and rear uprights (hard) for IF14-2 and IF14-2FWD.
This set is convenient for when you want to replace these items together for maintenance. It is also more economical than purchasing each item individually.
By adding these wheel shims between the hex wheel hub and the wheel, you can fine-tune the cars track width quickly. Available in two thicknesses of 0.25mm and 0.5mm. 8pcs are included in each.
A lightweight DJ CVD cross spider using high strength super duralium (A7075) to reduce the weight by approx 36% compared with standard steel. High durability is also achieved by applying a hard alumite treatment. Used in combination with T227LW lightweight DJ CVD joint it is possible to reduce the weight by about 2g per driveshaft.
Spare part for floating electronic plate set. The plate can also function as a center chassis stiffener by adding one more screw to the chassis.
This spacer sits between the lower suspension block and the chassis to adjust the roll center. With a thickness of 0.2mm it's possible to achieve fine detailed setup.
Compared with the std kit 2.0mm thickness, further chassis flex is gained and initial steering response increased. A great match for use with optional Aluminum Super Flex Main Chassis (T345SF)
