T315 - ALU CVD DRIVE SHAFT SET (Hard Anodized)

Steering block bushing to be used in combination with T332 C hub set (-1.0mm/4 degrees).
Used on the upper side of T332.

A vivid red anodized version has been added to the aluminum spacer series (3mm in inner diameter). It helps you dress up your machine. If you use this red anodized version and the black version in different specifications in a setting, you can easily distinguish them.

Short type (80mm) antenna pipe and cap set.

1.5x8mm PIN (8pcs)

Lightweight DJ CVD joint that is approx 1.2g lighter than standard steel (approx 1.8g) by using lightweight and high strength super duralium (A7075). Throttle response is improved by reducing the rotating mass, while front tyre wear and understeer is reduced.