B051508 - 1.5x8mm PIN (8pcs)

IF14 pro gear diff set with aluminium outdrive cup specification. This set is about 2.2 grams lighter than the steel outdrive cup specification. This allows you to adjust the weight balance of the vehicle front and rear while also improving the throttle response.

Spare Part for IF14-2 Team Edition

Spare Part for IF14-2 Team Edition

Spare Part for IF14-2 Team Edition

This ALU ECCENTRIC BEARING HOLDER 0.5mm is 0.3mm less offset than the standard bearing holder. This allows you to have a wider choice of adjustment with a 0.3mm lower diff in the 'high' position and 0.3mm higher in the 'low' position. This part is machined from high quality aluminium for minimised drivetrain loss.

General-Purpose Item

Steering block bushing to be used in combination with T332 C hub set (-1.0mm/4 degrees).
Used on the upper side of T332.

0.5mm thinner than kit normal(5mm). Usefull to make the width narrow.