These bearings are the same high-spec bearings used by INFINITY team drivers during big races such as World Championships. These precision bearings are not only super smooth but also extremely durable.
The smallest spacer/insert (0.5cc) from spacer set R0331 that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. This thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.
This Urethane belt provides high durability under harsh conditions such as driving on dusty or dirty tracks, high temperatures or long finals. The belt teeth are hard and highly accurate offering good compatibility with the tooth profile and material of the pulleys helping to maintain excellent drive efficiency.
Front Shock Stay LD(Lay Down)WIDE features a position 2mm wider each side than the R0336. Offers increased initial response than R0336. It is designed to be lower so that it does not interfere with the body even when a modern body is installed. Thickness is 2.5mm.
Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for -1mm/+1mm (trail/reverse trail) of the upper pivot.
When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.
The material and coating have been updated to significantly improve crash resistance and durability compared to the standard items. The shaft is highly durable and resistant to scratches even after long periods of use.
Body stiffener for 1/8 body (Only large type for rear)
Bearing support rigidity has been greatly improved by increasing the roundness of the bearing cavity area as much as possible using a special molding process that has never been used before. This provides a higher consistency of rear traction.
Changed contents of conventional R0117 (changed to 1 piece).
Changed to 1 piece to make it easier to purchase as a spare part.
A spacer/insert set that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. The thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.
Lightweight and strong 64 titanium material is precision-machined to increase the overall length and ensure rigidity even when the rear upper arm is set at its longest setting. (Use with R0343 is recommended)
These bearings are the same high-spec bearings used by INFINITY team drivers during big races such as World Championships. These precision bearings are not only super smooth but also extremely durable.
