R0345 - TITANIUM REAR UPPER ROD(Long Type/21.6mm)

By extending the upper arm ball end boss by 3.5mm, the upper arm can be lengthened without any difficulty. The hole in the upper arm itself, which is combined with the upper arm, is also deeper, so it can be used in its shortest setting. Its now possiible to use this part for wide range of settings.

This carbon plate is used in combination with R00220L long front body post to increase the rigidity around the front bulkhead. Response in initial steering is increased while still maintaining a mild steering feel in the middle part of the corner. Also offering a weight saving of 4g the standard kit body mounting.

Long life rubber belt

A spacer/insert set that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. The thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.(1.5cc Upper&Bottom Spacer each 1pc.0.5cc Spacer 2pcs,M3x10mm/M3x12mm/M3x14mm screw each 1pc)

Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for -1mm/+1mm (trail/reverse trail) of the upper pivot.

When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.

The smallest spacer/insert (0.5cc) from spacer set R0331 that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. This thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.

This Urethane belt provides high durability under harsh conditions such as driving on dusty or dirty tracks, high temperatures or long finals. The belt teeth are hard and highly accurate offering good compatibility with the tooth profile and material of the pulleys helping to maintain excellent drive efficiency.

Bearing support rigidity has been greatly improved by increasing the roundness of the bearing cavity area as much as possible using a special molding process that has never been used before. This provides a higher consistency of rear traction.

Spare part for R0337

Titanium UFO head screw. Offers a lightweight design while maintaining contact surface area.

The material and coating have been updated to significantly improve crash resistance and durability compared to the standard items. The shaft is highly durable and resistant to scratches even after long periods of use.

Spare part for R0333.