R0241-2.7 - REAR SWAY BAR 2.7mm (IF18)

Option part for IF18. This aluminum body mount spacer is to be used together with the optional 1 piece carbon mounting plate (R0198) Offers extra body post stability and is available in both silver and red.

DISCONTINUED

Change of contents of conventional R0067 (to 1 piece).
Changed to 1 piece to make it easier to purchase as a spare part.

Spare parts for R0323.

To change ackerman angle (more increase angle of outside front tyre)

The smallest spacer/insert (0.5cc) from spacer set R0331 that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. This thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.

Black based INFINITY logo decal

Body stiffener for 1/8 body (Only small type)

DISCONTINUED

Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for -1mm/+1mm (trail/reverse trail) of the upper pivot.

When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.