R0188 - ALUMINIUM FRONT UPPER ARM HOLDER BUSHING 4pcs

Reverse movement from the standard type

Changed to long upper arm

R0262, R0263 Repair parts for accessories. Because it is an ultra-low head type with 1.5 mm hex hole and a thickness of 1.2 mm, it can be used in various tight spaces.

This Titainium screw set for the IF18 will effectively reduce the weight of the lower section of the car. Using these screws will slightly increase chassis flexibility allowing you to tune your car setup for any conditions. The set contains a total of 47pcs offering a weight saving of 12g over the standard steel screws.

By moving the 3x11.8mm pin position of the universal shaft through
90 degrees this allows for a more free drive transmission at high RPM and a smoother suspension
movement under high load, overall offering an increased steering feel.

 Use with R0188

Easy to check fuel

Maintenance and adjustability is greatly improved with this servo saver arm by mounting to the steering rod upper side.  Also, by changing and optimizing the arm length of the servo saver, the steering response will be higher than before.