R8014 - FRONT SPRING φ2.0-7T
16 other products in the same category:
Maintenance and adjustability is greatly improved with this servo saver arm by mounting to the steering rod upper side. Also, by changing and optimizing the arm length of the servo saver, the steering response will be higher than before.
Making the material harder than the standard kit version the flex of the suspension holder is reduced and steering response is improved. Offers a slightly milder steering feeling than the optional Aluminium version (R0191/R0187)
A new aluminium servo horn designed specifically for IF18. 25T specification for servos made by Savox (SC2271SG) and Futaba (BLS371SV). By making the shape of the arm offset it is possible to achieve the maximum steering angle with a linear steering operation. Use in combination with R0259 Aluminium servo saver (up side).
Making the material harder than the standard kit version the flex of the arm is reduced and rear traction is increased. Offering increased consistency in high grip and high temperature conditions.
Making the material harder than the standard kit version the flex of the arm is greatly reduced. Offering increased response at high speed and improved consistency in high grip and high temperature conditions.
To change ackerman angle (more increase angle of outside front tyre)
To change ackerman angle (more increase angle of outside front tyre)
This black aluminium screw set for the IF18 will significantly reduce the weight of the upper section of the car while also adding a fresh cool look. Using these screws willoffer a mild driving characteristic by increasing chassis flexibility in a well-balanced manner. The set contains a total of 111pcs offering a weight saving of 30g over the standard steel screws.
Wide roll bar adds further stability when holding the car and refuelling.
As used by the team drivers at the 2019 World Championships. The chassis offers increased corner speed while also offering a smoother feel, this has been achieved by changing the shape of both the front and the rear of the chassis.
It is also possible to change the characteristics for different track conditions by adding a carbon plate (sold separately) to increase rigidity of the front section and adding an M3 screw to the rear.
Replacement parts for R0026 FUEL TANK. 2pcs of P-18 Silicone O-Ring.
Possible to adjusting flex by cutting front rib