Made of superior quality 1.6mm thickness of U.S.A. carbon material.
Compare with kit normal thickness 2.0mm, further chassis flex is gained and initial steering response can be increased.
Provides great efficiency use with optional Aluminum Flex Main Chassis(T109).

Adding this spacer 1pc at each lower suspension holder, same rate can be derived with the eccentric bushing the position 0.5.
With this smart spacer, no need to taking off suspension holder for speedy operation.

The new suspension holder provides 0.5mm lower than kit normal hinge pin point. Possible to lower the roll center. Combination of roll center and toe angle option, setting range is widen.

The new suspension holder provides 0.5mm lower than kit normal hinge pin point. Possible to lower the roll center. Combination of roll center and toe angle option, setting range is widen.

The new suspension holder provides 0.5mm lower than kit normal hinge pin point. Possible to lower the roll center. Combination of roll center and toe angle option, setting range is widen.

Aluminum spool outdrive with shining antiwear hard anodized coating. Made by 7075 T6 material.
Comparing normal type per car, approx. 6.8g light weight. Better throttle response achieved.
Use with C-Blade protector (T124) for drive shaft.