• New

A2530 - INFINITY CARBON RULER (30cm)

Cool carbon fiber ruler with 5-star INFINITY logo.
Made of carbon fiber, which is strong, lightweight, and has no distorstion due to heat, allowing for accurate measurements.
Available in two sizes: 15 cm and 30 cm.


16 other products in the same category:

A0096XL - INFINITY TEAM HOODIE "4 STARS" (BK) XL size

INFINITY Team Hoodie has been renewed with the World Champion "4 Star" design!


The "4 Star" design represents the number of World Championships Team INFINITY has won. The design is a subtle yet proud reflection of Team INFINITY's brilliant achievements to date. Although it is a thin type, it is brush lined for a comfortable feel and excellent warmth retention. Seven sizes are available: S/M/L/XL/2XL/3XL/4XL.

  • New

G272 - HYBRID SERVO SAVER SET (IF15-2/IF15-2W)

The combination of carbon and aluminum materials provides sharp steering characteristics with a highly rigid and lightweight finish. In addition, the included 4.9mm ball and aluminum spacer optimize bump steer and increase corner speed.

T112 - D.J.CVD DRIVE SHAFT 42mm

Reviewed steering angle, front D.J.CVD drive shaft.
With use of aluminum bell crank (T093), smoothly can provide the drive power at wide steering angle.
Assemblage of wheel axle and drive shaft must be Ver.2 -to-Ver.2

T126 - LW ALU CVD DRIVE SHAFT SET

New axle shaft is high-duty concrete steel material used. Grind extremely to the limit and achieved light weight.
Fit together perfectly with the drive shaft material 7075 T6 made in Japan.
Black anodized drive shaft is light weight and "INFINITY" logo is marked.
M3 set screw is used at universal spider for simple operation.
Each parts are finished as possible as smooth that is with zero waste for further cornering speed and throttle response.

  • New

M095 - 45T DIFF SPUR GEAR

The 45T spur gear contributes to boosting the top speed of your vehicle and may potentially reduce fuel consumption under specific conditions. Additionally, it aids in achieving a smoother power delivery on low-traction tracks.

T122 - VZ REAR UPRIGHT (Hard)

Newly designed rear upright, geometry of suspension system is optimized. Toe angle is zero.
Mounting position of upper arm is optimized at higher point, shim of 2.0mm to be reduced.
Lineup of Hard & Graphite material. Hard material suits for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.