T151 - O-RING for PRO-GEAR DIFF (2pcs)

The newly designed gear differential for IF14 offers smooth rotation and high rear traction in all conditions. The differential shafts are now supported by ball bearings for added stability and consistency during runs.  Outdrive cups can now be replaced from the outside without the need to open the diff making maintenance quick and easy.

The belt roller set will prevent skipping of rear belt of IF14.
When it occurs deflection under huge load on the belt, helps the belt to keep at proper position.
It provides stability of traction and brake control. It lengthens the life of belt.
※No combined usage with T095 REAR BALANCE WEIGHT.

This ALU ECCENTRIC BEARING HOLDER 0.5mm is 0.3mm less offset than the standard bearing holder. This allows you to have a wider choice of adjustment with a 0.3mm lower diff in the 'high' position and 0.3mm higher in the 'low' position. This part is machined from high quality aluminium for minimised drivetrain loss.

By adding these wheel shims between the hex wheel hub and the wheel, you can fine-tune the cars track width quickly. Available in two thicknesses of 0.25mm and 0.5mm. 8pcs are included in each.

The new suspension holder provides 0.5mm lower than kit normal hinge pin point. Possible to lower the roll center. Combination of roll center and toe angle option, setting range is widen.

This is a new set of super strong and high-precision 4.9mm titanium ball ends for the IF14. Each set is about 8g lighter than the steel ones and the polished ball surface ensures the ball end moves smoothly for a long time.

This is a new set of super strong and high-precision 4.9mm titanium ball ends for the IF14. Each set is about 8g lighter than the steel ones and the polished ball surface ensures the ball end moves smoothly for a long time.

Newly designed rear upright, geometry of suspension system is optimized. Toe angle is zero.
Mounting position of upper arm is optimized at higher point, shim of 2.0mm to be reduced.
Lineup of Hard & Graphite material. Hard material suits for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.

Newly designed steering block. Steering angle stopper is additionally equipped.
Steering is adjustable at any angle of incidence. Lineup of Hard & Graphite material.
Hard material is suitable for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.

New standard Short-type shock springs (20mm). We selected wire 1.4mm in diameter and accurately coiled and plated it. Gold: 5 Coils For high- grip asphalt road surface Made in Japan

0.75mm thinner than kit normal(5mm). Usefull to make the width narrow.

Cooling fan mount made of composite material that is half the weight of aluminum and super lightweight.