G072-20 - 2nd PINION GEAR 20T

Spare parts for repairing short shocks that can be used for IF15/IF15W.

Dedicated one O-ring specification.
The overall length has been reduced to the utmost limit to achieve a low center of gravity.
Teflon coated surface for smooth operation.

High-grade Japanese bearings are used to create an extremely smooth drivetrain. The INFINITY logo is also included to prove that it is team spec.

Spare parts for repairing short shocks that can be used for IF15/IF15W.

Overall length of 24mm.

These engine mounts are specially designed for the O.S.12 engine. They are lowered and allow the engine crankcase to sit right at the chassis level contributing to a lower center of gravity.
The cooling fins on the sides allows the engine to better dissipate heat and help prevent overheating during a race.
(Do not use with non- O.S. engines as the crankcase and chassis may interfere with each other.)

For IF15 / IF15W
Developed based on team driver feedback
A new carbon camber plate that can be adjusted in fine steps. The diagonal direction of the holes incorporates the latest setups for the IF15.
The bottom hole is the same original hole 2 (lower), the more you raise it, the more calm the rear will be.
(Part of the outer ball end needs to be cut)

Spare part for G164.

A high-quality 64 titanium ball screw set, when replacing the kit's standard φ8mm ball screws (front/steel, rear/aluminum), they reduce overall weight by approximately 3.3g and provides a light driving feel.