R0314 - FRONT KNUCKLE BASE 13.5(IF18-2)
The front roll center can be lowered by replacing the kit parts with this front knuckle base. With these adjustments your IF18-II has the potential for even higher turning/steering performance. Recommended for use with thick front stabilizer from 2.6 - 3.0mm.
16 other products in the same category:
R0256 - BUMPER SPACER SET
NEW Option part for IF18.
Insert under front bumper to adjust body height where needed.
Ideal when running on bumpy race tracks.
Will offer a smoother driving feel.
Includes M4mm Aluminium Nylon Nut & M4x12mm Titanium Flat Head Screw.
R0336W - FRONT SHOCK STAY LD (IF18-2) WIDE
Front Shock Stay LD(Lay Down)WIDE features a position 2mm wider each side than the R0336. Offers increased initial response than R0336. It is designed to be lower so that it does not interfere with the body even when a modern body is installed. Thickness is 2.5mm.
R0252T19 - 0.8M 1st PINION GEAR 19T
A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.
R0321 - ALUMINIUM FRONT LOWER ARM HOLDER SET each 4pcs (IF18-2)
This part is machined from high quality 7075 aluminium material. With the significantly increased rigidity the steering response will be improved. Plastic bushings to hold the suspension shaft and mounting screws are included.
The front roll center can be lowered by replacing the kit parts with this front knuckle base. With these adjustments your IF18-II has the potential for even higher turning/steering performance. Recommended for use with thick front stabilizer from 2.6 - 3.0mm.