R0337S05 - BODY MOUNT PIVOT

Spare parts for R0323.

Long life rubber belt

Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for central alignment of the upper pivot (0mm kit standard zero offset).

When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.

Titanium UFO head screw. Offers a lightweight design while maintaining contact surface area.

Body stiffener for 1/8 body

Option part for Infinity IF18. This brake disc offers a more stable braking performance during long runs. The disc is made from thicker material than the standard item and also vented to efficiently dissipate heat. Improved brake feeling, spring included.

By extending the upper arm ball end boss by 3.5mm, the upper arm can be lengthened without any difficulty. The hole in the upper arm itself, which is combined with the upper arm, is also deeper, so it can be used in its shortest setting. Its now possiible to use this part for wide range of settings.

Easy to check fuel

3.0mm shorter/Good matching for standard INFINITY(CM-00001)

DISCONTINUED

These bearings are the same high-spec bearings used by INFINITY team drivers during big races such as World Championships. These precision bearings are not only super smooth but also extremely durable.

A spacer/insert set that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. The thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.

The front roll center can be lowered by replacing the kit parts with this front knuckle base. With these adjustments your IF18-II has the potential for even higher turning/steering performance. Recommended for use with thick front stabilizer from 2.6 - 3.0mm.