R0075-60 - FRONT UNIVERSAL SWING SHAFT (L 60) 2pcs

Reverse movement from the standard type

This new option part for IF18 is a set of 4 large diameter aluminium counter sink washers M4x12mm. Used for fixing the engine mounts to the chassis the flat surface means a super secure fitting and sufficient range of movement for all gear mesh. They can also be used with other 1/8 scale on road models.

DISCONTINUED

Spare part for R0337

3.0mm shorter/Good matching for standard INFINITY(CM-00001)

Body stiffener for 1/8 body (Only small type)

Reverse movement from the standard type

Spare part for R0337

Spare part for R0337

Adjust the amount of spring tension on your clutch nut quickly and easily without disassembling the clutch bell. Featuring the Infinity logo the tool is also finished in black and red to match the brands striking colours.

Installing this part significantly improves rigidity to the rear section of the chassis around the gear area, enabling more reliable power transmission, increasing acceleration and top speed. In addition to this the increased pitching rigidity of the chassis helps to add initial response and a sharper steering feel.

Uses lightweight carbon material. Chassis rigidity can be increased while suppressing weight increase. Improves steering response.

Now available as individual parts. R0303 is discontinued.

Front Shock Stay LD(Lay Down) that offers a position one step lower than the conventional R0081 (included in the kit). The center position of the R0336 is the same as the lower hole of the R0081. It's designed to be lower so that it does not interfere with the body even when a modern body is installed. Thickness is 2.5mm.