T308SH - STEERING BLOCK / REAR UPRIGHT SET (IF14-2/Super Hard)
One car set of steering block and rear uprights (graphite/super hard) for IF14-2 and IF14-2FWD.
This set is useful when changing from the kit's standard hardware, or when you want to replace these parts together for maintenance. It is also more economical than purchasing each item individually.
16 other products in the same category:
T271 - IF14 ULTRA LOW FRICTION LOWER ARM SHAFT SET
High precision and high strength stainless steel lower arm shafts plated with a special lubricant to reduce resistance and provide ultra smooth suspension movement. Offers ultimate suspension performance.
T254 - FLOATING ELECTRONIC PLATE WEIGHT SET 15g
A floating electronics plate which allows the receiver, ESC and motor cooling fan to be easily installed and removed from the chassis. Helps ease of maintenance and allows for quicker chassis changes.
T332B - C-HUB SET (-1.0mm/4deg./for Body Upstop)
C-Hub set with added mounting holes for the body upstop (T358). Be sure to use T332B when using T358.
* The conventional T332 will be discontinued once the stock runs out.
T200-0.2 - LOWER SUSPENSION BLOCK SPACER RF 0.2mm (SUS/4pcs)
This spacer sits between the lower suspension block and the chassis to adjust the roll center. With a thickness of 0.2mm it's possible to achieve fine detailed setup.
T261 - GRAPHITE FRONT BODY POST SUPPORT
This front bumper brace improves the rigidity of the bumper and body posts, helping stability around the front section at high speed. Made from lightweight and highly rigid carbon, the product surface is also specially embossed to achieve a stylish design which includes the INFINITY logo. Your IF14-2 will look even more dialled with this brace installed.
T270 - LIGHT WEIGHT D.J.CVD CROSS SPIDER (4pcs)
A lightweight DJ CVD cross spider using high strength super duralium (A7075) to reduce the weight by approx 36% compared with standard steel. High durability is also achieved by applying a hard alumite treatment. Used in combination with T227LW lightweight DJ CVD joint it is possible to reduce the weight by about 2g per driveshaft.
T346 - GRAPHITE TOP DECK 1.6mm (TE MID)
Compared with the std kit 2.0mm thickness, further chassis flex is gained and initial steering response increased. A great match for use with optional Aluminum Super Flex Main Chassis (T345SF)
One car set of steering block and rear uprights (graphite/super hard) for IF14-2 and IF14-2FWD.
This set is useful when changing from the kit's standard hardware, or when you want to replace these parts together for maintenance. It is also more economical than purchasing each item individually.