This is a spare part for short shock G147 for IF15/IF15W. 2 hole - 1.1mm piston. (3 hole - 0.9mm piston and 1 hole - 1.3mm is also available.
This piston is secured with an ultra small screw as used in the IF14-2 to increase stroke.
A dedicated 0.05" inch size tool is required. (A0100) INFINITY 0.05" hex wrench driver.
Front upper arm spacer for IF15. By inserting these shims between the front upper arm holder and the upper deck its possible to fine tune the roll center and camber change rate, enabling smooth and high speed cornering.
Replacement parts for G125 Adjustable front one way set. For use when cup and shaft see general wear and tare.
This shock tower is used in combination with a specially developed short-type shock.
The suspension stroke is equal to that of the standard type, and combined with the low center of gravity, the shocks provide increased response and cornering.
The front and rear mounting positions are also carefully designed to keep the upper and lower mounting surfaces the same.
The upper fixing surface is offset by 1mm to keep the upper and lower mounting surfaces the same, the shape takes advantage of the machined A7075 material.
In the case of use with IF15W the racing body SMJ C235 can be optimized and mounted 3.5mm lower when using G147 short front shock set.
Made of lightweight 7075 aluminum with hard coating.
Low gear ratio for short technical tracks.
This is a 9.5g chassis weight for IF15. By combining it with 14g and 28 chassis weights, the option parts already available, you can make finer tune-up.
A high-quality 64 titanium ball screw set, when replacing the kit's standard φ8mm ball screws (front/steel, rear/aluminum), they reduce overall weight by approximately 3.3g and provides a light driving feel.
This is an option part for short shock for IF15/IF15W. 3 hole - 0.9mm piston. (3 hole - 0.9mm and 2 hole - 1.1mm piston is also available.
This piston is secured with an ultra small screw as used in the IF14-2 to increase stroke.
A dedicated 0.05" inch size tool is required. (A0100) INFINITY 0.05" hex wrench driver.
Spare parts for repairing short shocks that can be used for IF15/IF15W.
Dedicated one O-ring specification.
The overall length has been reduced to the utmost limit to achieve a low center of gravity.
Teflon coated surface for smooth operation.
This is a spare part for short shock G147 for IF15/IF15W. 2 hole - 1.1mm piston. (3 hole - 0.9mm piston and 1 hole - 1.3mm is also available.
This piston is secured with an ultra small screw as used in the IF14-2 to increase stroke.
A dedicated 0.05" inch size tool is required. (A0100) INFINITY 0.05" hex wrench driver.
