A spacer/insert set that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. The thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.(1.5cc Upper&Bottom Spacer each 1pc.0.5cc Spacer 2pcs,M3x10mm/M3x12mm/M3x14mm screw each 1pc)
This carbon plate is used in combination with R00220L long front body post to increase the rigidity around the front bulkhead. Response in initial steering is increased while still maintaining a mild steering feel in the middle part of the corner. Also offering a weight saving of 4g the standard kit body mounting.
Uses harder material than standard IF18 kit. Increases the rigidity of the suspension and improves the corner speed.
This tension roller flange prevents the middle belt from accidentally falling off in high load situations such as high temps or extreme high traction. Fixed in place so as not to increase rotating mass of the roller it is also shaped to prevent any step between the belt and the flange. Offered in black and titian colour. (Can also be used for IF15. Please use the included M3x15mm screw.)
A carbon stiffener that can be added to the front lower arm to increase rigidity. Increased steering response and higher cornering speeds can be achieved in certain conditions. Its also possible to adjust the flex and rigidity by the number of mounting screws used.
This tension roller flange prevents the middle belt from accidentally falling off in high load situations such as high temps or extreme high traction. Fixed in place so as not to increase rotating mass of the roller it is also shaped to prevent any step between the belt and the flange. Offered in black and titian colour. (Can also be used for IF15. Please use the included M3x15mm screw.)
This part is machined from high quality 7075 aluminium material. With the significantly increased rigidity the steering response will be improved. Plastic bushings to hold the suspension shaft and mounting screws are included.
The smallest spacer/insert (0.5cc) from spacer set R0331 that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. This thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.
Bearing support rigidity has been greatly improved by increasing the roundness of the bearing cavity area as much as possible using a special molding process that has never been used before. This provides a higher consistency of rear traction.
A spacer/insert set that matches the fuel tank capacity of IF18-2 with the regulations of international races such as IFMAR. The thinnest spacer is 0.5cc, allowing you to make fine adjustments to the tank capacity by increasing or decreasing the number spacers.(1.5cc Upper&Bottom Spacer each 1pc.0.5cc Spacer 2pcs,M3x10mm/M3x12mm/M3x14mm screw each 1pc)
