T049B - STEEL BALL END 4.9mm SHORT (4pcs)

Adding this spacer 1pc at each lower suspension holder, same rate can be derived with the eccentric bushing the position 0.5.
With this smart spacer, no need to taking off suspension holder for speedy operation.

Adjustable the range of servo horn four stages at 17, 18, 19, 20mm. Since leverage can be set fixed, the setting is possible in a quantitiative way.
Exquisitely machined from High-intensity alloy aluminum. Can fit to other chassis than IF14. (25 spline)

Newly designed rear upright, geometry of suspension system is optimized. Toe angle is zero.
Mounting position of upper arm is optimized at higher point, shim of 2.0mm to be reduced.
Lineup of Hard & Graphite material. Hard material suits for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.

This is a new set of super strong and high-precision 4.9mm titanium ball ends for the IF14. Each set is about 8g lighter than the steel ones and the polished ball surface ensures the ball end moves smoothly for a long time.

Newly designed steering block. Steering angle stopper is additionally equipped.
Steering is adjustable at any angle of incidence. Lineup of Hard & Graphite material.
Hard material is suitable for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.

Newly designed rear upright, geometry of suspension system is optimized. Toe angle is zero.
Mounting position of upper arm is optimized at higher point, shim of 2.0mm to be reduced.
Lineup of Hard & Graphite material. Hard material suits for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.

Material is softer than kit normal. Higher drive efficiency achieved by narrowed belt. Exclusive use for stock motor.

Newly designed steering block. Steering angle stopper is additionally equipped.
Steering is adjustable at any angle of incidence. Lineup of Hard & Graphite material.
Hard material is suitable for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.

Since its hard stiffness effect, improved steering response can be provided.
Newly designed shape achieved further steering angle.
In case this aluminum bell crank equipped, please use together with D.J.CVD Ver2(T110).

Cooling fan mount made of composite material that is half the weight of aluminum and super lightweight.

Reviewed steering angle, front D.J.CVD drive shaft.
With use of aluminum bell crank (T093), smoothly can provide the drive power at wide steering angle.
Assemblage of wheel axle and drive shaft must be Ver.2 -to-Ver.2