The T142 drive belt is wider than T105 drive belt amking it the perfect choice for high power motors. Due to the low friction characteristics of the product, T142 drive belt has a shorter life than the drive belt included in the kit. If you use T142 drive belt with a modified motor, conduct maintenance regularly and replace the belt as necessary.
The advanced "PRS system" is designed to deliver faster cornering speeds for the IF14-2. This system allows for the rear toe angle to be controlled passively as a result of the rear suspension arm stroke. The cornering characteristics can be fine-tuned by adjusting the mounting angle of the linkage rod.
By adding these wheel shims between the hex wheel hub and the wheel, you can fine-tune the cars track width quickly. Available in two thicknesses of 0.25mm and 0.5mm. 8pcs are included in each.
Made of superior quality 1.6mm thickness of U.S.A. carbon material.
Compare with kit normal thickness 2.0mm, further chassis flex is gained and initial steering response can be increased.
Provides great efficiency use with optional Aluminum Flex Main Chassis(T109).
Motor mount and center shaft mount are assembled separately. Enable the chassis flex of motor mount area softer. Changing screw position, characteristics of flexibility can be adjusted. Additionally, characteristics of flexibility can be adjusted by changing screw position.
Reviewed steering angle, front D.J.CVD drive shaft.
With use of aluminum bell crank (T093), smoothly can provide the drive power at wide steering angle.
Assemblage of wheel axle and drive shaft must be Ver.2 -to-Ver.2
0.75mm thinner than kit normal(5mm). Usefull to make the width narrow.
This is a smaller foam bumper for the IF14 which features a chamfered leading edge making it more suitable for the latest breed racing body shells. SMJ zero gap tape can be used for fine tuning.
0.5mm thinner than kit normal(5mm). Usefull to make the width narrow.
The most advanced "PRS system" will deliver faster cornering speed for IF14.
As a function of stroke from suspension arm, toe angle is controled passively.
Amount of toe angle is fine-tuned by mounting angle of linkage rod.
Height of steering block is alternative of two types and roll-center can be adjusted .
The system is capable of various track condition or layout of the corner.
This ALU ECCENTRIC BEARING HOLDER 0.5mm is 0.3mm less offset than the standard bearing holder. This allows you to have a wider choice of adjustment with a 0.3mm lower diff in the 'high' position and 0.3mm higher in the 'low' position. This part is machined from high quality aluminium for minimised drivetrain loss.
This is a set of 4.9mm ball ends made of strong and high-precision hard steel. The screw part is shorter than the 7mm ones. The ball surface is smoother than that of the conventional one (T050), yet sold at a competitive price.
