The new suspension holder provides 0.5mm lower than kit normal hinge pin point. Possible to lower the roll center. Combination of roll center and toe angle option, setting range is widen.
Including 40mm size high speed cooling fan is mounted at back side of motor. Fan is fixed with two screws on the red anodized aluminum fan mount. Since this fan mount is fixed on chassis by one screw so as hardly can not effect chassis flex. Mount is usable for 30mm and 40mm size fan.
※ Not combination usage with T095 Rear balance weight (Left side).
※ Limited-production item.
Approx. of 13g heavy weight than kit normal carbon graphite chassis. Suitable for the car to make more lower gravity center like carpet or high-grip surface.
Optimized chassis shape design will provide perfect chassis flex.
Adding this spacer 1pc at each lower suspension holder, same rate can be derived with the eccentric bushing the position 0.5.
With this smart spacer, no need to taking off suspension holder for speedy operation.
Newly designed rear upright, geometry of suspension system is optimized. Toe angle is zero.
Mounting position of upper arm is optimized at higher point, shim of 2.0mm to be reduced.
Lineup of Hard & Graphite material. Hard material suits for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.
0.75mm thinner than kit normal(5mm). Usefull to make the width narrow.
It is preventable G-Clip accidentally comming off during running.
Its approx. of 0.2mm thickness provide no weight extendability.
Shutterproof of grease and lenghtening life-span of the parts and maintenance cycle.
Cut about 10mm for each. Fitting on effectively, provide little heating after inserted.
Alignment tool to accurately assemble the IF14-2 lower bulkhead, upper bulkhead and shock tower.
