R0322 - ALUMINIUM FRONT UPPER ARM HOLDER SET (IF18-2)
Upper arm holder machined from 7075 aluminuim material. The strength and rigidity are increased providing higher corner speed in certain conditions. The black anodized finish complete with Infinity logo also add a cool look to your car.
16 other products in the same category:
R0328 - ALUMINIUM CENTERING BUSHING (IF18-2)
Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for central alignment of the upper pivot (0mm kit standard zero offset).
When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.
R0253T23 - 0.8M 2nd PINION GEAR 23T
A new lineup of pinion gears for the IF18-2 with a hard coating on 7075 aluminium material. Offered in all teeth sizes to fine tune gear ratio according to the engine and track layout.
R0336W - FRONT SHOCK STAY LD (IF18-2) WIDE
Front Shock Stay LD(Lay Down)WIDE features a position 2mm wider each side than the R0336. Offers increased initial response than R0336. It is designed to be lower so that it does not interfere with the body even when a modern body is installed. Thickness is 2.5mm.
R0342 - REAR UPRIGHT(Precision Type/IF18-2)
Bearing support rigidity has been greatly improved by increasing the roundness of the bearing cavity area as much as possible using a special molding process that has never been used before. This provides a higher consistency of rear traction.
Upper arm holder machined from 7075 aluminuim material. The strength and rigidity are increased providing higher corner speed in certain conditions. The black anodized finish complete with Infinity logo also add a cool look to your car.