R0081W - FRONT SHOCK STAY (CARBON GRAPHITE) WIDE

IF18 logo decal. Pre-cut decal is easy to attach. Size: 210mmx148mm

Spare part for R0333.

Bearing support rigidity has been greatly improved by increasing the roundness of the bearing cavity area as much as possible using a special molding process that has never been used before. This provides a higher consistency of rear traction.

Machined from high quality A7075 aluminium material. IF18-2 knuckle upper and lower insert. Prevents misalignment during a crash and enhances steering response during cornering. This bushing is used for central alignment of the upper pivot (0mm kit standard zero offset).

When assembling these parts first remove the front knuckle upper. Place the offset bush into the knuckle upper from the outside. Then pass both M3x14mm slim head screws through the knuckle upper from the inside and tighten the 3mm nylon nut on the outside.

Uses a softer material than the standard R0303-01. Increases crash resistance. The steering response is also mild.
(M2x8mm Flat Head Screw is not included.)

The front roll center can be lowered by replacing the kit parts with this front knuckle base. With these adjustments your IF18-II has the potential for even higher turning/steering performance. Recommended for use with thick front stabilizer from 2.6 - 3.0mm.

For rear only

A vivid red anodized version has been added to the aluminum spacer series (3mm in inner diameter). It helps you dress up your machine. If you use this red anodized version and the black version in different specifications in a setting, you can easily distinguish them.

Option part for IF18. This aluminum body mount spacer is to be used together with the optional 1 piece carbon mounting plate (R0198) Offers extra body post stability and is available in both silver and red.

Spare parts for R0323.

Titanium UFO head screw. Offers a lightweight design while maintaining contact surface area.