This is a new set of super strong and high-precision 4.9mm titanium ball ends for the IF14-2.
Each set is about 8g lighter than the steel ones and the polished ball surface ensures the ball end moves smoothly for a long time.
By reducing the rigidity of the front shock tower connecting point to the upper bulkhead, the stiffness around the front bulkhead section is reduced and the overall chassis flex is increased, resulting in a calmer initial steering response. This reduction in initial stiffness helps smooth out cornering and can help reduce tyre wear.
By adding these wheel shims between the hex wheel hub and the wheel, you can fine-tune the cars track width quickly. Available in two thicknesses of 0.25mm and 0.5mm. 8pcs are included in each.
This spacer sits between the lower suspension block and the chassis to adjust the roll center. With a thickness of 0.2mm it's possible to achieve fine detailed setup.
Adjust the chassis flex by connecting this carbon brace between the upper bulkheads on top of the top deck. This upper bulkhead brace is cut with high precision from 1mm carbon plate and can change the steering and traction characteristics by effecting the rigidity of the front or rear bulkheads.
Front of top deck: Good balance between high-speed and low-speed corner.
Rear of top deck: Good balance between rotation and traction.
An extra hard lower suspension arm using a graphite material. This arm is more stiff than the original kit version and is suitable for high grip tracks and in situations when you want to improve initial steering response.
This ALU ECCENTRIC BEARING HOLDER 0.5mm is 0.3mm less offset than the standard bearing holder. This allows you to have a wider choice of adjustment with a 0.3mm lower diff in the 'high' position and 0.3mm higher in the 'low' position. This part is machined from high quality aluminium for minimised drivetrain loss.
Adjustable the range of servo horn four stages at 17, 18, 19, 20mm. Since leverage can be set fixed, the setting is possible in a quantitiative way. Exquisitely machined from High-intensity alloy aluminum. Can fit to other chassis than IF14. (23 spline)
