This titanium screw is for attaching the shock mounting to the IF14-II shock tower. It can be used to fine tune the steering feeling and grip between aluminium and steel.
7.5g balancing weight that can be attached to the 15g center weight or the aluminum electronic plate mount. Weight balance can be adjusted by the mounting position and the number of weights.
New standard Short-type shock springs (20mm). We selected wire 1.4mm in diameter and accurately coiled and plated it. Gold: 5 Coils For high- grip asphalt road surface Made in Japan
It is preventable G-Clip accidentally comming off during running.
Its approx. of 0.2mm thickness provide no weight extendability.
Shutterproof of grease and lenghtening life-span of the parts and maintenance cycle.
Cut about 10mm for each. Fitting on effectively, provide little heating after inserted.
An extra hard lower suspension arm using a graphite material. This arm is more stiff than the original kit version and is suitable for high grip tracks and in situations when you want to improve initial steering response.
Compared with the std kit 2.0mm thickness, further chassis flex is gained and initial steering response increased. A great match for use with optional Aluminum Super Flex Main Chassis (T345SF)
This spacer sits between the lower suspension block and the chassis to adjust the roll center. With a thickness of 0.2mm it's possible to achieve fine detailed setup.
Adjust the chassis flex by connecting this carbon brace between the upper bulkheads on top of the top deck. This upper bulkhead brace is cut with high precision from 1mm carbon plate and can change the steering and traction characteristics by effecting the rigidity of the front or rear bulkheads.
Front of top deck: High-speed corner steering is increased. Low-speed corner steering decreased.
Rear of top deck: Increased rotation in the rear. Understeer is reduced. On power traction slightly reduced.
Hex socket head screws machined from high-quality 6-4 titanium material.
With a larger head outer diameter (approximately 3.7mm) than the typical button head, they allow for secure fastening of parts.
Lightweight DJ CVD joint that is approx 1.2g lighter than standard steel (approx 1.8g) by using lightweight and high strength super duralium (A7075). Throttle response is improved by reducing the rotating mass, while front tyre wear and understeer is reduced.
