T239 - FRONT BELT TENSIONER SET

This spacer sits between the lower suspension block and the chassis to adjust the roll center. With a thickness of 0.2mm it's possible to achieve fine detailed setup.

Newly designed rear upright, geometry of suspension system is optimized. Toe angle is zero.
Mounting position of upper arm is optimized at higher point, shim of 2.0mm to be reduced.
Lineup of Hard & Graphite material. Hard material suits for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.

7.5g balancing weight that can be attached to the 15g center weight or the aluminum electronic plate mount. Weight balance can be adjusted by the mounting position and the number of weights.

A floating electronics plate which allows the receiver, ESC and motor cooling fan to be easily installed and removed from the chassis. Helps ease of maintenance and allows for quicker chassis changes.

Narrower than kit standard (5mm). Aluminum hex wheel hub series. Width can be set more narrow.
When used on the front, it improves steering response. When used on the rear, it improves traction.

One car set of steering block and rear uprights (graphite/super hard) for IF14-2 and IF14-2FWD.
This set is useful when changing from the kit's standard hardware, or when you want to replace these parts together for maintenance. It is also more economical than purchasing each item individually.

Alignment tool to accurately assemble the IF14-2 lower bulkhead, upper bulkhead and shock tower.

Short type (41mm) front drive shaft rather than the kit standard front drive shaft (42mm).
Offers a linear steering feel, making the car easier to drive when used in high traction or oversteer situations.

Spare Part for IF14-2 Team Edition

Newly designed steering block. Steering angle stopper is additionally equipped.
Steering is adjustable at any angle of incidence. Lineup of Hard & Graphite material.
Hard material is suitable for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.

Drive belt for TE MID (common to front and rear)

0.75mm thinner than kit normal(5mm). Usefull to make the width narrow.