T241 - ALU DIFF OUTDRIVE (2pcs)

A lightweight DJ CVD cross spider using high strength super duralium (A7075) to reduce the weight by approx 36% compared with standard steel. High durability is also achieved by applying a hard alumite treatment. Used in combination with T227LW lightweight DJ CVD joint it is possible to reduce the weight by about 2g per driveshaft.

An aluminum cooling fan mount that can be bolted to the floating electronic plate with a 30mm fan for motor cooling.

A full set of lower suspension arms (hard) for IF14-2 and IF14-2FWD for one car.
This set is convenient when you want to replace lower suspension arms together for maintenance. It is also more economical than purchasing each item individually.

C-Hub set with added mounting holes for the body upstop (T358). Be sure to use T332B when using T358.
* The conventional T332 will be discontinued once the stock runs out.

Conversion set to convert IF14-2 Team Edition (TE) to MID motor layout. Smooth cornering characteristics and improved weight transfer reduce the load on the rear tires, making lap times more consistent during the latter part of a race.

Standard part for T265.

High precision and high strength stainless steel lower arm shafts plated with a special lubricant to reduce resistance and provide ultra smooth suspension movement. Offers ultimate suspension performance.

Lightweight DJ CVD joint that is approx 1.2g lighter than standard steel (approx 1.8g) by using lightweight and high strength super duralium (A7075). Throttle response is improved by reducing the rotating mass, while front tyre wear and understeer is reduced.

Hex socket head screws machined from high-quality 6-4 titanium material.
With a larger head outer diameter (approximately 3.7mm) than the typical button head, they allow for secure fastening of parts.