SMJ1019 - ZERO GAP FOAM BUMPER for PF LTC-R (BD7, CX11)

New axle shaft is high-duty concrete steel material used. Grind extremely to the limit and achieved light weight.
Fit together perfectly with the drive shaft material 7075 T6 made in Japan.
Black anodized drive shaft is light weight and "INFINITY" logo is marked.
M3 set screw is used at universal spider for simple operation.
Each parts are finished as possible as smooth that is with zero waste for further cornering speed and throttle response.

Newly designed rear upright, geometry of suspension system is optimized. Toe angle is zero.
Mounting position of upper arm is optimized at higher point, shim of 2.0mm to be reduced.
Lineup of Hard & Graphite material. Hard material suits for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.

This ALU ECCENTRIC BEARING HOLDER 0.5mm is 0.3mm less offset than the standard bearing holder. This allows you to have a wider choice of adjustment with a 0.3mm lower diff in the 'high' position and 0.3mm higher in the 'low' position. This part is machined from high quality aluminium for minimised drivetrain loss.

The shock tower Ver.B is made up after continuous feedback from Team INFINITY drivers in the worlds
Newly designed shock positions will provide you stable grip balance in various condition.
Perfectly suitable when you like to make the driving feel milder than kit normal.

This is a set of 4.9mm ball ends made of strong and high-precision hard steel. The screw part is shorter than the 7mm ones. The ball surface is smoother than that of the conventional one (T050), yet sold at a competitive price.

Adding this spacer 1pc at each lower suspension holder, same rate can be derived with the eccentric bushing the position 0.5.
With this smart spacer, no need to taking off suspension holder for speedy operation.

It is preventable G-Clip accidentally comming off during running.
Its approx. of 0.2mm thickness provide no weight extendability.
Shutterproof of grease and lenghtening life-span of the parts and maintenance cycle.
Cut about 10mm for each. Fitting on effectively, provide little heating after inserted.

This shock spring retaining collar is for INFINITY IF14 shock. Made of precisely machined aluminium its extremely light and helps the shock absorber and the shock spring work more efficiently. The set contains 4pcs. of black-anodized shock spring retaining collars.

Reviewed steering angle, front D.J.CVD drive shaft.
With use of aluminum bell crank (T093), smoothly can provide the drive power at wide steering angle.
Assemblage of wheel axle and drive shaft must be Ver.2 -to-Ver.2