T150 - OUTDRIVE CUP for PRO-GEAR DIFF

Made of superior quality 1.6mm thickness of U.S.A. carbon material.
Compare with kit normal thickness 2.0mm, further chassis flex is gained and initial steering response can be increased.
Provides great efficiency use with optional Aluminum Flex Main Chassis(T109).

Adding this spacer 1pc at each lower suspension holder, same rate can be derived with the eccentric bushing the position 0.5.
With this smart spacer, no need to taking off suspension holder for speedy operation.

Alignment tool to accurately assemble the IF14-2 lower bulkhead, upper bulkhead and shock tower.

Including 40mm size high speed cooling fan is mounted at back side of motor. Fan is fixed with two screws on the red anodized aluminum fan mount. Since this fan mount is fixed on chassis by one screw so as hardly can not effect chassis flex. Mount is usable for 30mm and 40mm size fan.
※ Not combination usage with T095 Rear balance weight (Left side).
※ Limited-production item.

It is preventable G-Clip accidentally comming off during running.
Its approx. of 0.2mm thickness provide no weight extendability.
Shutterproof of grease and lenghtening life-span of the parts and maintenance cycle.
Cut about 10mm for each. Fitting on effectively, provide little heating after inserted.

This ALU ECCENTRIC BEARING HOLDER 0.5mm is 0.3mm less offset than the standard bearing holder. This allows you to have a wider choice of adjustment with a 0.3mm lower diff in the 'high' position and 0.3mm higher in the 'low' position. This part is machined from high quality aluminium for minimised drivetrain loss.

This is a new set of super strong and high-precision 4.9mm titanium ball ends for the IF14. Each set is about 8g lighter than the steel ones and the polished ball surface ensures the ball end moves smoothly for a long time.

Cooling fan mount made of composite material that is half the weight of aluminum and super lightweight.

Aluminum spool outdrive with shining antiwear hard anodized coating. Made by 7075 T6 material.
Comparing normal type per car, approx. 6.8g light weight. Better throttle response achieved.
Use with C-Blade protector (T124) for drive shaft.

This is a smaller foam bumper for the IF14 which features a chamfered leading edge making it more suitable for the latest breed racing body shells. SMJ zero gap tape can be used for fine tuning.

This is a set of 4.9mm ball ends made of strong and high-precision hard steel. The screw part is shorter than the 5mm ones. The ball surface is smoother than that of the conventional one (T049), yet sold at a competitive price.