T152 - SHIM 3x9x0.2mm (4pcs)

16 other products in the same category:

T049B - STEEL BALL END 4.9mm SHORT (4pcs)

This is a set of 4.9mm ball ends made of strong and high-precision hard steel. The screw part is shorter than the 5mm ones. The ball surface is smoother than that of the conventional one (T049), yet sold at a competitive price.

T126 - LW ALU CVD DRIVE SHAFT SET

New axle shaft is high-duty concrete steel material used. Grind extremely to the limit and achieved light weight.
Fit together perfectly with the drive shaft material 7075 T6 made in Japan.
Black anodized drive shaft is light weight and "INFINITY" logo is marked.
M3 set screw is used at universal spider for simple operation.
Each parts are finished as possible as smooth that is with zero waste for further cornering speed and throttle response.

T144 - WHEEL SHIM 0.5mm (SUS/8pcs)

By adding these wheel shims between the hex wheel hub and the wheel, you can fine-tune the cars track width quickly. Available in two thicknesses of 0.25mm and 0.5mm. 8pcs are included in each.

T123 - VZ REAR UPRIGHT (Graphite/Super Hard)

Newly designed rear upright, geometry of suspension system is optimized. Toe angle is zero.
Mounting position of upper arm is optimized at higher point, shim of 2.0mm to be reduced.
Lineup of Hard & Graphite material. Hard material suits for fundamental condition and provides stable grip.
For high grip surface and expecting quick response, graphite material is recommended to use.

T091 - ALU ADJUSTABLE SERVO HONE (for SANWA)

Adjustable the range of servo horn four stages at 17, 18, 19, 20mm. Since leverage can be set fixed, the setting is possible in a quantitiative way. Exquisitely machined from High-intensity alloy aluminum. Can fit to other chassis than IF14. (23 spline)

T099 - ALU COOLING FAN MOUNT (with FAN/Red)

Including 40mm size high speed cooling fan is mounted at back side of motor. Fan is fixed with two screws on the red anodized aluminum fan mount. Since this fan mount is fixed on chassis by one screw so as hardly can not effect chassis flex. Mount is usable for 30mm and 40mm size fan.
※ Not combination usage with T095 Rear balance weight (Left side).
※ Limited-production item.

T051B - STEEL BALL END 4.9mm LONG (4pcs)

This is a set of 4.9mm ball ends made of strong and high-precision hard steel. The screw part is shorter than the 9mm ones. The ball surface is smoother than that of the conventional one (T051), yet sold at a competitive price.