We recommend using the Chassis Mounted Alu. Steering Post when better steering response is needed. INFINITY red anodized production visually effects everyone.
By adding these wheel shims between the hex wheel hub and the wheel, you can fine-tune the cars track width quickly. Available in two thicknesses of 0.25mm and 0.5mm. 8pcs are included in each.
The advanced "PRS system" is designed to deliver faster cornering speeds for the IF14-2. This system allows for the rear toe angle to be controlled passively as a result of the rear suspension arm stroke. The cornering characteristics can be fine-tuned by adjusting the mounting angle of the linkage rod.
This is a smaller foam bumper for the IF14 which features a chamfered leading edge making it more suitable for the latest breed racing body shells. SMJ zero gap tape can be used for fine tuning.
The most advanced "PRS system" will deliver faster cornering speed for IF14.
As a function of stroke from suspension arm, toe angle is controled passively.
Amount of toe angle is fine-tuned by mounting angle of linkage rod.
Height of steering block is alternative of two types and roll-center can be adjusted .
The system is capable of various track condition or layout of the corner.
By adding these wheel shims between the hex wheel hub and the wheel, you can fine-tune the cars track width quickly. Available in two thicknesses of 0.25mm and 0.5mm. 8pcs are included in each.
Including 40mm size high speed cooling fan is mounted at back side of motor. Fan is fixed with two screws on the red anodized aluminum fan mount. Since this fan mount is fixed on chassis by one screw so as hardly can not effect chassis flex. Mount is usable for 30mm and 40mm size fan.
※ Not combination usage with T095 Rear balance weight (Left side).
※ Limited-production item.
Alignment tool to accurately assemble the IF14-2 lower bulkhead, upper bulkhead and shock tower.
This is a new set of super strong and high-precision 4.9mm titanium ball ends for the IF14. Each set is about 8g lighter than the steel ones and the polished ball surface ensures the ball end moves smoothly for a long time.
Cooling fan mount made of composite material that is half the weight of aluminum and super lightweight.
This is a set of 4.9mm ball ends made of strong and high-precision hard steel. The screw part is shorter than the 9mm ones. The ball surface is smoother than that of the conventional one (T051), yet sold at a competitive price.
Material is softer than kit normal. Higher drive efficiency achieved by narrowed belt. Exclusive use for stock motor.
0.5mm thinner than kit normal(5mm). Usefull to make the width narrow.
We recommend using the Chassis Mounted Alu. Steering Post when better steering response is needed. INFINITY red anodized production visually effects everyone.
